HP Workstation x2000 Manuel d'utilisateur télécharger pdf (Page 11)

HP x2000 Service Information

System Board Connectors, BIOS, and Memory

Chapter 1 11

6. Open the Zero Insertion Force (ZIF) lever, located at the side of the

processor socket, until it is in the vertical position (depending on the

socket design, the handle may need to go past vertical), then carefully

lift out the processor. To avoid bending the processor pins, keep the

processor perfectly ﬂat when removing it. See Figure 1-1.

7. Store the processor in an anti-static bag (for example, the one

provided with the replacement processor).

Installing the New Processor

1. First ensure the processor is correctly oriented, then carefully lower

the new processor into place. When the processor is fully inserted,

close the ZIF lever.

Figure 1-2 Inserting the Processor

2. Carefully remove any thermal bonding material that may have

remained on the underside of the heatsink.

Figure 1-3 Removing the Bonding Material

3. Afﬁx the new thermal interface material (sticker or polymer, provided

with the new processor) to the top side of the new processor.

4. Attach the heatsink onto the processor. If there are retaining clips,

use them to attach the heatsink. For easier access, attach the rear

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

HP Workstation x2000 Manuel d'utilisateur Page 11