HP All in One Printer 4000 Manuel d'utilisateur Page 291

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 360
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 290
3. Reinsert the printhead into the carriage and check the front panel message.
4. If the problem remains, try a new printhead.
An ink cartridge status message
These are the possible ink cartridge status messages:
OK: the cartridge is working normally, with no known problems
Missing: there is no cartridge present, or it is not properly connected to the printer
Low: the ink level is low
Very low: the ink level is very low
Empty: the cartridge is empty
Reseat: you are recommended to remove the cartridge and then reinsert it
Replace: you are recommended to remove the cartridge and then reinsert it; if that fails, replace
the cartridge with a new cartridge
Altered: there is something unexpected about the cartridge's status—perhaps it has been refilled
A printhead status message
These are the possible printhead status messages:
OK: the printhead is working normally, with no known problems
Missing: there is no printhead present, or it is not properly installed in the printer
Reseat: you are recommended to start the printhead removal process from the front panel (see
Remove a printhead), but instead of removing the printhead, just press the Select key on the
front panel
Replace: you are recommended to remove the printhead and then reinsert it; if that fails, clean
the electrical connections; if that fails, replace the printhead with a new printhead
Remove: the printhead is not a suitable type for use in printing (for instance, a setup printhead)
A printhead cleaner status message
These are the possible printhead cleaner status messages:
OK: the cleaner is working normally, with no known problems
Missing: there is no cleaner present, or it is not properly installed in the printer
Reseat cleaner: you are recommended to remove the cleaner and then reinsert it
Wrong stall: the cleaner has been installed in the wrong place
End of life: the cleaner has reached the end of its planned lifetime
Not replaced with printhead: you have installed a new printhead without installing the new
cleaner that came with it
If a printhead cleaner needs to be removed or reseated, you must start the printhead replacement
process (see
Remove a printhead). Open the window when prompted to do so by the front panel. If
ENWW An ink cartridge status message 277
The problem is... (ink
system topics)
Vue de la page 290
1 2 ... 286 287 288 289 290 291 292 293 294 295 296 ... 359 360

Commentaires sur ces manuels

Pas de commentaire