HP Officejet 7310 All-in-One Printer Guide d'installation télécharger pdf (Page 12)

Problem: The Remove and check print cartridges message appears after

you insert print cartridges.

Action: Remove print cartridges. Make sure you remove all tape from copper

contacts. Close the access door.

Problem: You did not see the screen prompting you to connect the USB cable.

Action: Remove, and then re-insert the HP all-in-one Windows CD. Refer to

Section A.

Problem: The Microsoft Add Hardware screen appears.

Action: Click Cancel . Unplug the USB cable, and then insert the HP all-in-one

Windows CD. Refer to Section A.

Problem: The Device Setup Has Failed To Complete screen appears.

Action: Verify that the control-panel overlay is ﬁ rmly attached. Unplug the

HP all-in-one and plug it in again. Check all connections. Make sure the USB cable

is plugged into the computer. Do not plug the USB cable into a keyboard or non-

powered hub. Refer to Section A.

Problem: The Macintosh software does not install.

Action: Make sure the USB cable is plugged into the computer before installing

the software. Do not plug the USB cable into a keyboard or non-powered hub. Refer

to Section A. For network software problems, see the Network Guide.

Refer to the User Guide for more information. Printed on recycled paper.

Visit www.hp.com/support for assistance.

Troubleshooting

Problem: The paper has jammed.

Action: Turn off the device, and then remove the two-sided printing accessory.

Gently pull out any paper. Re-insert the printing accessory. Turn the device on. Load

the paper again.

*Q3461-90206*

Q3461-90206

*Q3461-90206*

1 2 ... 7 8 9 10 11 12

Pas de commentaire

HP Officejet 7310 All-in-One Printer Guide d'installation Page 12