HP OMNIBOOK 5000 Manuel d'utilisateur télécharger pdf (Page 52)

5. Remove the new memory-expansion board from its packaging and position it over

the connectors. Press in the board until it seats fully.

6. Replace the slot cover.

7. Insert the battery.

8. Press the reset button, in the small opening on the left side of the OmniBook—see

“To reset the OmniBook”. When prompted, run the System Configuration utility to

save the new memory configuration.

9. In Control Panel, double-click the Enhanced icon, then choose Virtual Memory and

Change.

10. First clear the Use 32-Bit File Access option—then select this option again. This

updates the Cache Size setting.

11. Choose OK to save the new setting. When prompted, choose Restart Windows to

activate the new setting.

Preparing the New Memory

You don’t need to adjust any settings after installing memory in your OmniBook.

Windows normally adjusts it settings automatically according to the amount of memory

present and the amount of unused disk space available on drive C.

Preparing the

New Memory

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 101 102

Pas de commentaire

HP OMNIBOOK 5000 Manuel d'utilisateur Page 52