HP Pro 3000 Guide de l'utilisateur télécharger pdf (Page 17)

Torn documents Documents with paper clips or

staples

Carbon paper Coated paper

Extremely thin, translucent paper Paper with adhesive notes or flags

attached

Photos Overhead transparencies

Papers that are stuck together Paper where the toner has not fully

dried, or with wet substances such as

glue or correction fluid

●

Smooth out any folds or curls in your documents before placing them into the feeder. If the

leading edge of a document is curled or folded, it may cause a paper jam.

● When loading paper that is smaller than 74 mm (2.9 in) in one dimension (such as business

cards), place the pages with the short side parallel to the paper guides.

●

To scan fragile documents (such as photos or documents on wrinkled or very lightweight paper),

place the document in a clear, heavyweight document sleeve no wider than 215.9 mm (8.5 in)

before loading them into the document feeder.

TIP: If you do not have an appropriately-sized document sleeve, consider using a sleeve

intended for use in a ring binder. Trim the ring-side edge so the sleeve is no more than 215.9

mm (8.5 in) wide.

●

Make sure that the hatch on the document feeder is securely latched. To properly close the

hatch, press firmly on both sides of the hatch until you hear both sides click.

●

Adjust the paper guides to the width of the documents. Make sure that the paper guides touch

the edges of the original. If there is any clearance between the paper guides and the edges of

the documents, the scanned image might be skewed.

●

When placing a stack of documents into the feeder, gently set the stack in the document feeder.

Do not drop the stack into the feeder and do not tap the top edge of the stack after you have

placed the stack in the document feeder.

●

Clean the scan rollers if the rollers are visibly dirty or after scanning a document written with or

written on with pencil.

ENWW

Load originals

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 59 60

Pas de commentaire

HP Pro 3000 Guide de l'utilisateur Page 17