HP SmartCard NIPRNet Solution for US Government Manuel d'utilisateur télécharger pdf (Page 2)

3.1

3.2

4.1 4.3A

4.2 B

Locate and open the hardware integration pocket (HIP) on the printer/MFP.

1. The HIP is covered by a rectangular cover that is retained by clips along its long edges.

2. Using a thin, at-blade screwdriver along either short edge, gently pry the cover o. Figure 3.1 shows various models of printers and MFPs.

Install the HP Smartcard reader using the HIP.

Attach the short USB cable to the USB connector in the HIP.

NOTE: Before connecting the USB cable, verify that the printer/MFP is turned o.

1. Locate the USB connector that is along one of the short edges. A USB Mini B receptacle (4.1) is the most common. However, some models, use a

USB Mini B plug (4.2).

2. Select the appropriate short cable from the two provided.

3. Attach one end of the provided short USB cable to the USB connector in the HIP.

1 2 3 4 5 6 7 8

Pas de commentaire

HP SmartCard NIPRNet Solution for US Government Manuel d'utilisateur Page 2