HP B.06.X Manuel d'utilisateur télécharger pdf (Page 32)

Installing and Configuring PPU Software

Configuring PPU Software

Chapter 332

Manually Starting the ppud Daemon

The ppud daemon is started automatically when you specify the utility

meter using the /usr/sbin/ppuconfig -m meter command. It is also

automatically started at system boot if a utility meter is configured.

However, the ppud daemon’s process may have inadvertently been killed

on the system/partition. If the ppud daemon is not running on your PPU

system/partition, you need to start it manually.

NOTE The ppud daemon must be running on each PPU system/partition,

including virtual partitions. If the ppud daemon is not running on your

system/partition, utilization information is not sent to HP and 100%

utilization may be assumed.

To verify the ppud daemon is running, execute the following command:

/usr/bin/ps -e | grep ppud

You should see the ppud daemon listed as an active process on the

system/partition. If it is running, and the utility meter is properly

configured, utilization information is sent to HP and your PPU

system/partition is correctly configured.

If the ppud daemon is not listed as an active process, you can manually

start the ppud daemon with the following command:

/sbin/init.d/ppu start

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 77 78

Pas de commentaire

HP B.06.X Manuel d'utilisateur Page 32