HP High Performance LC Cluster series Manuel d'installation télécharger pdf (Page 35)

Execute the following command.

% /opt/clusterpack/bin/compute_config

Step 14 Set up HyperFabric (optional)

Background

The utility clnetworks assists in setting up a HyperFabric network within a cluster. For clnetworks to

recognize the HyperFabric (clic) interface, it is necessary to first install the drivers and/or kernel patches

are needed.

Once the clic interface is recognized by lanscan, clnetworks can be used to set (or change) the IP address

configure the card.

The HyperFabric interfaces can be grouped into a network entity using clnetworks. The network entity

e assigned an extension that forms the aliases to use for the HyperFabric interfaces. Use these names w

you want to explicitly communicate over the HyperFabric network. For example, if node002 has a

HyperFabric interface with the extension "hyp", ftp through this network can be achieved using:

% /usr/bin/ftp node002-hyp

otice that this command will only work from a node that has a HyperFabric interface.

Overview

Install the HyperFabric drivers and kernel patches.

Details

Use the swinstall command to install the following bundle:

HyprFabrc-00

Follow the installation instructions delivered to you with your HyperFabric installation kit.

Step 15 Set up InfiniBand (optional)

Background

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 172 173

Pas de commentaire

HP High Performance LC Cluster series Manuel d'installation Page 35