HP NAS 8000 Non-Clustered Solution Guide de l'utilisateur Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 88
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
8 Command Reference
getNetworkCardDhcpEnabled
Identifies whether the specified NIC is DHCP enabled.
When DHCP is enabled, NIC configuration occurs automatically. Depending on your
configuration, the DHCP server provides any or all of the following parameters: IP Address,
Subnet Mask, Gateway Address, Broadcast Address.
inParam[0] = Network card name
outParam[0] = T (Enabled) or F (Disabled)
setNetworkCardDhcpEnabled
Enables or disables DHCP for the specified NIC. If DHCP is disabled, the NIC IP address must be
manually defined.
inParam[0] = Network card name
inParam[1] = T (Enable) or F (Disable)
getNetworkCardEnabled
Identifies whether the specified NIC is enabled.
inParam[0] = Network card name
outParam[0] = T (Enabled) or F (Disabled)
getNetworkCardGatewayAddress
Returns the gateway address for the specified NIC.
inParam[0] = Network card name
outParam[0] = Gateway address
setNetworkCardGatewayAddress
Sets the gateway address for the specified NIC.
inParam[0] = Network card name
inParam[1] = Gateway address
getNetworkCardInterfaceName
Returns the name for the specified NIC.
InParam[0] = Network card (NIC)
OutParam[0] = Name
getNetworkCardIpAddress
Returns the IP address for the specified NIC.
inParam[0] = Network card
outParam[0] = IP address
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 87 88

Commentaires sur ces manuels

Pas de commentaire