a. Before installing HPWAM, install JRE 1.6 or later (64-bit version). For JRE
installationinstructions and downloads, go to www.java.com
b. If you have already installed HPWAM, the latest version can be installed over an existing
installation.
c. Run the installer located at: \Workload Accelerator Manager\Windows\Workload
Accelerator Manager-x86_64–Setup.exe
Updating the Device Driver (New or Existing Installation)
1. In the Windows Driver folder of the support pack, double-click the MicronP320hDriveX64 MSI
installer file. The Micron RealSSD PCIe Device Drivers <Driver-Version> Setup dialog box
displays. <Driver-Version> is the driver release version available in the current support pack.
2. Select the I accept the terms of the License Agreement check box and click the Install button
to continue. If you do not agree with the licensing terms, cancel the installation by clicking the
Cancel button. When cancelling, the Are you sure you want to cancel Micron RealSSD PCIe
Device Drivers <Driver_Version> installation? message displays. Click the Yes button and then
the Finish button to cancel installation.
3. If you accepted the license agreement, the Install dialog box displays a progress bar.
4. After the installation process completes, the Window Security dialog box displays the message
Would you like to install this device software? Click the Install button. Optionally, select the
Always trust software from "Micron Technology" check box.
5. Click theFinish button when the setup wizard indicates that the driver installation has completed.
6. The drive is installed and ready for use on your system. It may be necessary to open the
Windows Device Manager and click the Scan for Hardware Changes button to see the drive
and its driver.
Installing the HP PCIe Workload Accelerator Support Pack on a Linux System
This section describes how to install the HP PCIe Workload Accelerator software on a Linux system.
Start by shutting down your PC, then boot into Linux.
NOTE: Refer to the Readme document in the Linux Driver folder in the support pack for additional
notes on version-specific release behavior.
Installing the HP PCIe Workload Accelerator Driver for RHEL 5.5, 5.6, 5.7, and 5.8
For RHEL versions 5.5, 5.6, 5.7 and 5.8, the package name of our RHEL driver is
mtip32xx-<version>.x86_64_rhel5ux.
1. If a device driver was previously installed and your system has the HP driver version 1.2.30
or earlier, you must first uninstall the existing driver:
a. As a root user, run rpm -e <driver_name> where <driver-name> is mtip32xx (or mtip2xx
for version 1.2.30 or earlier).
b. As a root user, run depmod.
c. Reboot the system
2. For a new installation:
a. As a root user, run rpm -ivh <rpm-name> where <rpm-name> is
mtip32xx-<version>.x86_64_rhel5ux.rpm.
b. Run depmod.
c. Reboot the system.
3. To upgrade your driver to a newer version:
12 Installing the HP PCIe Workload Accelerator Software
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels