Hp StorageWorks X3000 Network Storage Systems Manuel d'utilisateur Page 95

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 130
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 94
Shared disk requirements
NOTE:
Do not allow more than one node access the shared storage devices at the same time until Cluster
service is installed on at least one node and that node is online. This can be accomplished through
selective storage presentation, SAN zoning, or having only one node online at all times.
All shared disks, including the Quorum disk, must be accessible from all nodes. When testing
connectivity between the nodes and the LUN, only one node should be given access to the LUN
at a time.
All shared disks must be configured as basic (not dynamic).
All partitions on the disks must be formatted as NTFS.
Cluster installation
During the installation process, nodes are shut down and rebooted. These steps guarantee that the
data on disks that are attached to the shared storage bus is not lost or corrupted. This can happen
when multiple nodes try to simultaneously write to the same disk that is not yet protected by the cluster
software.
Use Table 15 to determine which nodes and storage devices should be presented during each step.
Table 15 Power sequencing for cluster installation
CommentsStorage
Additional
Nodes
Node 1Step
Verify that all storage devices on the
shared bus are not presented; Power on
all nodes.
Not
Presented
OnOn
Setting up net-
works
Shut down all nodes. Present the shared
storage, then power on the first node.
PresentedOffOn
Setting up
shared disks (in-
cluding the Qur-
om disk)
Shut down first node, power on next
node. Repeat this process for all cluster
nodes.
PresentedOnOff
Verifying disk
configuration
Shut down all nodes; power on the first
node.
PresentedOffOn
Configuring the
first node
Power on the next node after the first
node is successfully configured. Com-
plete this process for all cluster nodes.
PresentedOnOn
Configuring addi-
tional nodes
At this point all cluster nodes should be
on.
PresentedOnOnPost-installation
To configure the Cluster service on the storage system, an account must have administrative permissions
on each node.
X1000 and X3000 Network Storage System 95
Vue de la page 94
1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 129 130

Commentaires sur ces manuels

Pas de commentaire