HP Tape Manuel d'utilisateur télécharger pdf (Page 74)

An external HP Surestore DLT1 drive will operate using any voltage in the range 100–240 volts (50-

60 Hz). No adjustment is needed. To connect your drive to the power supply, proceed as follows:

1 Plug the power cable securely into the socket on the rear panel of the drive. (See figure 3.)

2 Plug the other end of the power cable into the power outlet.

Write the model name, product number, serial number, and SCSI ID of your drive at the back of this

guide for future reference. The model name is on the front of the drive and the product and serial

numbers are on a label on the bottom of the drive.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 85 86

Pas de commentaire

HP Tape Manuel d'utilisateur Page 74