HP RP2 Manuel d'utilisateur télécharger pdf (Page 17)

7. Slide the new power supply into the left side of the base.

8. Connect the AC power cord to the right side of the power supply inside the base (1), insert the

cord into the routing slot on the bottom edge of the base (2), and then route the cord under the

base behind the foot (3) and out the rear of the base (4).

9. Route the DC cable on the left side of the base up through the hole in the center of the base and

connect the cable to the DC power connector on the rear of the display head.

Replacing the power supply 11

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 44 45

Pas de commentaire

HP RP2 Manuel d'utilisateur Page 17