HP C7185 Guide d'installation télécharger pdf (Page 14)

14 • HP All-in-One

Install software on additional computers

If you have additional computers on your network, install the

HP All-in-One software on each computer. Choose the correct

HP All-in-One CD for each installation.

Follow the onscreen instructions. Make sure that you choose the

connection types between the network and your HP All-in-One (not

between your computer and the network).

Troubleshooting

Problem: A Paper Jam message appears.

Action: Remove the back access door, and then gently pull out any paper. Turn the

device off, and then on. Load the paper again.

Problem: You did not see the screen prompting you to connect the USB cable.

Action: Remove, and then re-insert the HP All-in-One Windows CD. Refer to

Section A.

Problem: The Microsoft Add Hardware screen appears.

Action: Click Cancel . Unplug the USB cable, and then insert the HP All-in-One

Windows CD. Refer to Section A.

Problem: The Device Setup Has Failed To Complete screen appears.

Action: Verify that the control panel faceplate is ﬁ rmly attached. Unplug the

HP All-in-One and plug it in again. Check all connections. Make sure the USB

cable is plugged into the computer. Do not plug the USB cable into a keyboard or

non-powered hub. Refer to Section A.

Congratulations! Go to Step 18 of this Setup Guide

1 2 ... 9 10 11 12 13 14 15 16

Pas de commentaire

HP C7185 Guide d'installation Page 14