HP OmniBook 2000/5700 Manuel d'utilisateur télécharger pdf (Page 83)

Troubleshooting

Solving Basic Problems

5-5

Use the “step-by-step” option to step through each startup command to find

where problems occur, so you can repair or restore any files indicated.

• If drive C (the hard disk) isn’t working properly, insert the Support Utility floppy

disk in the floppy disk drive, then press

Ctrl+Alt+Del to reboot from drive A—

then click the Minimum Startup option. At the MS-DOS prompt, type

scandisk c: to fix certain problems with drive C. You can use other

commands on drive A to try to repair drive C. Then remove the floppy disk and

try rebooting again. If it still doesn’t start, try reinstalling the original Windows

95 files on drive C.

If your system password doesn’t work

• Check whether Num Lock is off. Try changing it.

• If you’ve forgotten your password, have your OmniBook at hand and call

Hewlett-Packard at the phone number in the Service and Support booklet.

If the screen is difficult to read

• Set the display resolution to its original setting—800×600 (SVGA) or 1024×768

(XGA). For Windows for Workgroups, use Display in OmniBook Tools. For

Windows 95, use Display in HP User Tools.

• Try adjusting the display controls below or to the right of the screen.

• Try changing the color scheme. For Windows for Workgroups, use Display in

OmniBook Tools. For Windows 95, use Display in HP User Tools.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 99 100

Pas de commentaire

HP OmniBook 2000/5700 Manuel d'utilisateur Page 83