Hp Smart Array P700m Controller Manuel d'utilisateur télécharger pdf (Page 11)

Configuring an array 11

Configuring an array

Utilities available for configuring an array

Two utilities are available for configuring an array on this controller:

• ORCA is a simple utility that is used mainly to configure the first logical drive in a new server before

the operating system is loaded.

• ACU is an advanced utility that enables you to perform many complex configuration tasks.

For more information about the features of these utilities and for instructions for using the utilities, see the

Configuring Arrays on HP Smart Array Controllers Reference Guide. This guide is available on the

Documentation CD that is provided in the controller kit.

Whichever utility you use, remember the following factors when you build an array:

• All drives in an array must be of the same type (for example, all SAS or all SATA).

• For the most efficient use of drive space, all drives within an array should have approximately the

same capacity. Each configuration utility treats every physical drive in an array as if it had the same

capacity as the smallest drive in the array. Any excess capacity of a particular drive cannot be used

in the array, and is unavailable for data storage.

• The more physical drives that there are in an array, the greater the probability that the array will

experience a drive failure during any given period. To guard against the data loss that occurs when

a drive fails, configure all logical drives in an array with a suitable fault-tolerance (RAID) method.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Pas de commentaire

Hp Smart Array P700m Controller Manuel d'utilisateur Page 11