Hp Smart Array P700m Controller Manuel d'utilisateur télécharger pdf (Page 17)

Upgrading or replacing controller options 17

10. Pull the right hand portion of the battery case away from the battery, and simultaneously rotate the

battery pack into the opening.

11. Connect the battery cable to the battery and the cache. Route the battery cable so that the cache

and battery can be removed together. (If you need to remove the cache to transfer data, the battery

must remain connected to it so that the data is preserved.)

12. Insert the battery case into the hard drive slot.

13. Close the server access panel.

14. Reinstall the server in the enclosure.

NOTE: After installing a battery pack, you might see a POST message during reboot

indicating that the array accelerator (cache) is temporarily disabled. This is normal, because

the new battery pack is likely to have a low charge. You do not need to take any action,

because the recharge process begins automatically when the battery pack is installed. The

controller will operate properly while the battery pack recharges, although the performance

advantage of the array accelerator will be absent. When the battery pack has been charged

to a satisfactory level, the array accelerator will automatically be enabled.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Pas de commentaire

Hp Smart Array P700m Controller Manuel d'utilisateur Page 17