HP Compaq Business Desktop dx2000 Informations techniques Page 94

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 106
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 93
D–20 359782-002 Service Reference Guide, dx2000 uT
Troubleshooting Without Diagnostics
Solving Memory Problems
Ä
CAUTION: For those systems that support ECC memory, HP does not support mixing ECC and non-
ECC memory. Otherwise, the system will not boot the operating system.
Solving Memory Problems
Problem Cause Solution
System will not boot or
does not function properly
after installing additional
memory modules.
Memory module is not
the correct type or
speed or the new
memory module is not
seated properly.
Replace module with the correct
industry-standard device for the
computer.
ECC memory modules are not
supported.
Out of memory error. Memory configuration
may not be set up
correctly.
Use the Device Manager to check
memory configuration.
You have run out of
memory to run the
application.
Check the application
documentation to determine the
memory requirements.
Memory count during
POST is wrong.
The memory modules
may not be installed
correctly.
Check that the memory modules
have been installed correctly and
that proper modules are used.
Insufficient memory error
during operation.
Too many Terminate
and Stay Resident
programs (TSRs) are
installed.
Delete any TSRs that you do
not
need.
You have run out of
memory for the
application.
Check the memory requirements for
the application or add more
memory to the computer.
Power LED flashes Red five
times, once every second,
followed by a two second
pause. Also, five
simultaneous beeps will be
heard.
Memory is installed
incorrectly or is bad.
1. Reseat DIMMs.
2. Replace DIMMs one at a time to
isolate the faulty module.
3. Replace third-party memory
with HP memory.
4. Replace the system board.
Vue de la page 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 105 106

Commentaires sur ces manuels

Pas de commentaire