Hp ProLiant DL380 G6 Server Manuel d'utilisateur Page 20
- Page / 117
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Component identification 20
Item ID Color Description
2
Green Auxiliary Power LED. This LED glows steadily when 3.3V
auxiliary voltage is detected. The auxiliary voltage is used
to preserve BBWC data and is available any time that the
system power cords are connected to a power supply.
3
Amber
Battery Health LED. To interpret the illumination patterns of
this LED, see the following table.
4
Green BBWC Status LED. To interpret the illumination patterns of
this LED, see the following table.
LED3 pattern LED4 pattern Interpretation
—
One blink every
two seconds
The system is powered down, and the cache contains data that has not
yet been written to the drives. Restore system power as soon as
possible to prevent data loss.
Data preservation time is extended any time that 3.3 V auxiliary
power is available, as indicated by LED 2. In the absence of auxiliary
power, battery power alone preserves the data. A fully-charged
battery can normally preserve data for at least two days.
The battery lifetime also depends on the cache module size. For further
information, refer to the controller QuickSpecs on the HP website
(http://www.hp.com).
—
Double blink, then
pause
The cache microcontroller is waiting for the host controller to
communicate.
—
One blink per
second
The battery pack is below the minimum charge level and is being
charged. Features that require a battery (such as write cache, capacity
expansion, stripe size migration, and RAID migration) are temporarily
unavailable until charging is complete. The recharge process takes
between 15 minutes and two hours, depending on the initial capacity
of the battery.
—
Steady glow The battery pack is fully charged, and posted write data is stored in the
cache.
—
Off The battery pack is fully charged, and there is no posted write data in
the cache.
One blink per
second
One blink per
second
An alternating green and amber blink pattern indicates that the cache
microcontroller is executing from within its boot loader and receiving
new flash code from the host controller.
Steady glow
— There is a short circuit across the battery terminals or within the battery
pack. BBWC features are disabled until the battery pack is replaced.
The life expectancy of a battery pack is typically more than three
years.
One blink per
second
— There is an open circuit across the battery terminals or within the
battery pack. BBWC features are disabled until the battery pack is
replaced. The life expectancy of a battery pack is typically more than
three years.
Hot-plug fans
CAUTION: To avoid damage to server components, fan blanks must be installed in fan bays 5
and 6 in a single-processor configuration.
- HP ProLiant DL380 G6 Server 1
- User Guide 1
- Contents 3
- Contents 4 4
- Contents 5 5
- Contents 6 6
- Component identification 7
- Front panel LEDs and buttons 8
- Systems Insight Display LEDs 9
- Rear panel components 11
- Rear panel LEDs and buttons 12
- System board components 13
- System maintenance switch 14
- NMI functionality 15
- SAS and SATA device numbers 16
- SAS and SATA hard drive LEDs 17
- PCI riser cage LEDs 18
- Battery pack LEDs 19
- Hot-plug fans 20
- Operations 22
- Remove the access panel 23
- Install the access panel 24
- Remove the PCI riser cage 26
- Install the PCI riser cage 26
- Remove the air baffle 27
- Rack planning resources 28
- Optimum environment 29
- Temperature requirements 30
- Power requirements 30
- Rack warnings 31
- Installing hardware options 31
- Setup 33 33
- Registering the server 34
- Introduction 35
- Processor option 35
- Install the heatsink 40
- Memory options 41
- DIMM identification 43
- Memory configurations 43
- Installing a DIMM 48
- Optical drive option 50
- Expansion board options 53
- PCI riser board option 56
- Hard drive cage option 57
- Cabling 63
- BBWC battery cabling 64
- Configuration and utilities 65
- HP ROM-Based Setup Utility 66
- Boot options 67
- BIOS Serial Console 67
- Configuring mirrored memory 67
- Array Configuration Utility 68
- Management tools 69
- ROMPaq utility 70
- Erase Utility 70
- Redundant ROM support 71
- Internal SD support 71
- Diagnostic tools 72
- Keeping the system current 73
- ProLiant Support Packs 74
- Care Pack 74
- Troubleshooting 75
- Symbols on equipment 76
- Warnings and cautions 76
- Symptom information 77
- Loose connections 79
- Service notifications 80
- Server health LEDs 80
- Troubleshooting flowcharts 80
- General diagnosis flowchart 81
- Symptoms: 83
- Troubleshooting 85 85
- POST problems flowchart 86
- OS boot problems flowchart 88
- Troubleshooting 89 89
- • Redundancy failure 90
- (http://www.hp.com/support) 91
- Troubleshooting 92 92
- Battery replacement 93
- FCC rating label 94
- Class A equipment 94
- Class B equipment 94
- Modifications 95
- • EMC Directive 2004/108/EC 96
- BSMI notice 97
- Korean notice 97
- Japanese notice 97
- Chinese notice 98
- Laser compliance 98
- Battery replacement notice 98
- Electrostatic discharge 100
- Specifications 101
- Technical support 104
- Technical support 105 105
- Customer Self Repair 106
- Technical support 107 107
- Reparo feito pelo cliente 108
- Technical support 109 109
- Technical support 110 110
- Technical support 111 111
- Acronyms and abbreviations 112
- Index 115 115
- Index 116 116
- Index 117 117
Produits connexes et manuels pour Matériel informatique Hp ProLiant DL380 G6 Server
(87 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.797 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels