HP XP48 Manuel du propriétaire télécharger pdf (Page 34)

HP SureStore E Disk Array XP512/XP48: Owner’s Guide

9 BS ON LED

(Yellow)

When the LED is on, unit is plugged in and receiving

power from the primary AC outlet. The SVP is

receiving power from the outlet.

If BS is off, then the disk array is not receiving power

from the primary AC outlet. Check the electrical outlets

in your building.

10 PS ON LED

(Green)

When the LED is on, the power switch is on, and the

array is ready to receive data.

Off means the power switch is off; the disk array is not

powered on and is not ready to receive data.

11 PWR SW ENABLE Switch Used to enable the PWR on/off switch. To enable the

PWR on/off switch, turn the PWR SW ENABLE switch

to the ENABLE position.

12 PWR ON/PWR OFF Switch To switch on/off the subsystem, use this switch while

turning the PWR SW ENABLE switch to the ENABLE

position. This switch is valid when the REMOTE/

LOCAL switch is set to the LOCAL position.

13 UNIT EMERGENCY

POWER OFF

Switch Used to power off the storage subsystem in an

emergency situation.

14 PWR ON/PWR OFF

REMOTE/LOCAL

Switch Determines how the disk array is powered on or off.

REMOTE: Disk array is powered on/off by the

instructions of the CPU.

LOCAL: Disk array is powered on/off by the PWR

ON/PWR OFF switch.

15 LED TEST/CHK

RESET

Switch LED TEST position: The LEDs on the panel go on.

CHK RESET position: The PS and THERMOCOUPLE

alarms are reset.

Table 3. Part Function on Control Panel (continued)

Item Label Indicator Description

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 123 124

Pas de commentaire

HP XP48 Manuel du propriétaire Page 34