HP ZBook 15 Base Model Mobile Workstation Manuel d'utilisateur télécharger pdf (Page 95)

Setting a MultiBoot Express prompt

To start Computer Setup and set the computer to display the MultiBoot startup location menu each

time the computer is started or restarted, follow these steps:

1. Turn on or restart the computer, and then press esc while the “Press the ESC key for Startup

Menu” message is displayed at the bottom of the screen.

2. Press f10 to enter Computer Setup.

3. Use a pointing device or the arrow keys to select System Configuration > Boot Options, and

then press enter.

4. In the MultiBoot Express Popup Delay (Sec) field, enter the length of time in seconds that you

want the computer to display the startup location menu before it defaults to the current MultiBoot

setting. (When 0 is selected, the Express Boot startup location menu is not displayed.)

5. To save your changes and exit Computer Setup, click the Save icon in the lower-left corner of

the screen, and then follow the on-screen instructions.

– or –

Use the arrow keys to select File > Save Changes and Exit, and then press enter.

Your changes go into effect when the computer restarts.

Entering MultiBoot Express preferences

When the Express Boot menu is displayed during startup, you have the following choices:

●

To specify a boot device from the Express Boot menu, select your preference within the allotted

time, and then press enter.

●

To prevent the computer from defaulting to the current MultiBoot setting, press any key before

the allotted time expires. The computer will not start until you select a boot device and press

enter.

● To allow the computer to start according to the current MultiBoot settings, wait for the allotted

time to expire.

Using System Diagnostics

System Diagnostics allows you to run diagnostic tests to determine if the computer hardware is

functioning properly. The following diagnostic tests may be available in System Diagnostics:

●

System Tune-Up—This group of additional tests checks your computer to make sure that the

main components are functioning correctly. System Tune-Up runs longer and more

comprehensive tests on memory modules, hard drive SMART attributes, the hard drive surface,

the battery (and battery calibration), video memory, and the WLAN module status.

●

Start-up test—This test analyzes the main computer components that are required to start the

computer.

● Run-in test—This test repeats the start-up test and checks for intermittent problems that the

start-up test does not detect.

●

Hard disk test—This test analyzes the physical condition of the hard drive, and then checks all

data in every sector of the hard drive. If the test detects a damaged sector, it attempts to move

the data to a good sector.

Using System Diagnostics 85

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 109 110

Commentaires sur ces manuels

Pas de commentaire

HP ZBook 15 Base Model Mobile Workstation Manuel d'utilisateur Page 95

Commentaires sur ces manuels

Produits connexes et manuels pour Carnets de notes HP ZBook 15 Base Model Mobile Workstation