HP 5900 switch - Enet Configuration Guide
Modified - 8 April 2013 Page 2
**Because of this you may want to remove static route once you are configured with commands:
system-view
undo ip route-static 0.0.0.0 0.0.0.0 10.20.126.208
save
By default, Telnet login is disabled.
To Log in through Telnet, complete the following configuration tasks:
• Enable the Telnet server function.
system-view
telnet server enable
• Configure an authentication mode for VTY login users. By default,
password authentication is used but no password is configured.
system-view
user-interface vty 0 (repeat for vty 1 and vty 2– will give you 3 potential telnet sessions)
authentication-mode none
• Assign a user role to VTY login users (network-operator by default).
user-role network-admin
• Set up IP address for Ethernet management interface, and add default route
system-view
interface M_GigabitEthernet0/0/0 ip address 10.20.126.208 255.255.255.0
ip route-static 0.0.0.0 0.0.0.0 10.20.126.208
save
3 Navigation
3.1 CLI Navigation
• To do almost any configuration, you have to be in the “system-view”
system-view
• To show anything, use “display”
display vlan 10
display interface brief
• To delete something use “undo” rather than the Cisco “no”
undo <command>
• To back up a level in the menu tree:
quit
Commentaires sur ces manuels