HP Pro 3380 Spécifications télécharger pdf (Page 196)

Insufficient memory error during operation.

Cause Solution

Too many Terminate and Stay Resident programs (TSRs)

are installed.

Delete any TSRs that you do not need.

You have run out of memory for the application. Check the memory requirements for the application or add

more memory to the computer.

Power LED flashes Red five times, once every second, followed by a two second pause, and the computer beeps

five times. (Beeps stop after fifth iteration but LEDs continue flashing.)

Cause Solution

Memory is installed incorrectly or is bad. 1. Reseat DIMMs. Power on the system.

2. Replace DIMMs one at a time to isolate the faulty

module.

3. Replace third-party memory with HP memory.

4. Replace the system board.

Solving Processor Problems

If you encounter processor problems, common causes and solutions are listed in the following table.

Table D-14 Solving Processor Problems

Poor performance is experienced.

Cause Solution

Processor is hot. 1. Make sure the airflow to the computer is not blocked.

2. Make sure the fans are connected and working properly

(some fans only operate when needed).

3. Make sure the processor heat sink is installed properly.

Power LED flashes Red three times, once every second, followed by a two second pause.

Cause Solution

Processor is not seated properly or not installed. 1. Check to see that the processor is present.

2. Reseat the processor.

186 Appendix D Troubleshooting Without Diagnostics

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 217 218

Pas de commentaire

HP Pro 3380 Spécifications Page 196