HP StorageWorks Disk System 2100 (fld rck 0 drvs) Manuel d'utilisateur télécharger pdf (Page 19)

HP StorageWorks Disk System 2100 / 2110

English

FIGURE 11

Installing a Disk Module

Configure the new Disk Module

Configure a new disk module within your application.

Remove and Replace A Disk Module

Remove a Disk Module

1 Ensure there is no activity on the drives.

If the Disk Drive LED for that disk module is flashing green, the disk drive is

active. When the Disk Drive LED off, the disk module is either idle or

completely off (see Table 1 on page 8). In this state, it is safe to remove the disk

module.

These procedures should be performed only by qualified system

administrator. Performing hot-plug operations on an active disk drive can

result in data loss or corruption.

If the disk system is running and a disk module slot does not contain a disk

drive or filler panel, the disk system will not cool properly and may

overheat. If you are not replacing the disk module immediately, a filler

panel must be installed to maintain proper cooling.

Ensure that you have a replacement disk or filler panel before removing the

disk module from the disk system unless you are returning a defective disk

system.

CAUTION

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

Pas de commentaire

HP StorageWorks Disk System 2100 (fld rck 0 drvs) Manuel d'utilisateur Page 19