HP 1055CM Manuel d'utilisateur télécharger pdf (Page 38)

System Error Codes

2-4

HP DesignJets 1050C and 1055CM Printers Service Manual

System Error: 010021 (Non-Continuable)

Problem

Description:

Memory DRAM DIMM Test failure.

Corrective Action: Try the following:

Switch the Power OFF from the back of the Printer and

disconnect the Power cord. Reseat the DRAM DIMMs (Memory

Modules), reconnect the power cord and power On the Printer.

If the Error Code appears again, switch the Power OFF,

disconnect the power cord and Replace the Flash DIMMs

(Memory Modules). Reconnect the power cord and power On the

Printer and check if the Error Code has been resolved.

If the Error Code continues, replace the Electronics Module ⇒

Page 8-25.

WARNING Only replace one component at a time and check if the error has

gone before replacing another component. Using this procedure

you will be able to determine exactly which component failed.

System Error: 010023 (Non-Continuable)

Problem

Description:

EEROM Test failure.

Corrective Action: Try the following:

Clear the EEROM ( ⇒ Page 4-38) and turn the Printer OFF and

ON again from the back of the Printer. If after clearing the

EEROM, the Error Code disappears, make sure you perform the

Calibrations Backup ⇒ Page 5-19.

NOTE Make sure that you select "Electronics Module Replaced" when

performing the Calibrations Backup.

If the Error Code continues, replace the Electronics Module ⇒

Page 8-25.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 321 322

Pas de commentaire

HP 1055CM Manuel d'utilisateur Page 38