HP 1055CM Manuel d'utilisateur télécharger pdf (Page 44)

System Error Codes

2-10

HP DesignJets 1050C and 1055CM Printers Service Manual

System Error: 060309

Problem

Description:

Problem with setting the Voltage of the Printheads.

Corrective Action: Try the following:

Remove ALL the Printheads and clean the flex contacts on the

Printheads and in the Carriage Assembly (Refer to Chapter 2).

Perform the Electronic Systems Test ⇒ Page 4-5.

Replace ALL the Printheads.

Replace the Trailing Cable ⇒ Page 8-39.

Replace the Carriage Assembly ⇒ Page 8-44.

If the Error Code continues, replace the Electronics Module ⇒

Page 8-25.

WARNING Only replace one component at a time and check if the error has

gone before replacing another component. Using this procedure

you will be able to determine exactly which component failed.

System Error: 06030A (Continuable)

Problem

Description:

Error in finding the Mark Encoder.

Corrective Action: Try the following:

Clean the Mark Encoder if necessary (use the Overdrive Cleaning

Utility to position the Mark Encoder ⇒ Page 4-37).

Clean the Line Sensor (located on the Carriage Assembly).

Perform the Line Sensor Calibration ⇒ Page 5-9.

Perform the Mark Encoder Calibration ⇒ Page 5-13.