HP DL320 - ProLiant - G3 Guide de l'utilisateur Page 57
- Page / 119
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Server software and configuration utilities 57
Automatic Server Recovery
ASR is a feature that causes the system to restart when a catastrophic operating
system error occurs, such as a blue screen, ABEND, or panic. A system fail-safe
timer, the ASR timer, starts when the System Management driver, also known as
the Health Driver, is loaded. When the operating system is functioning properly,
the system periodically resets the timer. However, when the operating system
fails, the timer expires and restarts the server.
ASR increases server availability by restarting the server within a specified time
after a system hang or shutdown. At the same time, the HP SIM console notifies
you by sending a message to a designated pager number that ASR has restarted
the system. You can disable ASR from the HP SIM console or through RBSU.
ROMPaq utility
Flash ROM enables you to upgrade the firmware (BIOS) with system or option
ROMPaq utilities. To upgrade the BIOS, insert a ROMPaq diskette into the
diskette drive and boot the system.
The ROMPaq utility checks the system and provides a choice (if more than one
exists) of available ROM revisions. This procedure is the same for both system
and option ROMPaq utilities.
For more information about the ROMPaq utility, refer to the HP website
(http://www.hp.com/servers/manage
).
System Online ROM flash component utility
The Online ROM Flash Component Utility enables system administrators to
efficiently upgrade system or controller ROM images across a wide range of
servers and array controllers. This tool has the following features:
• Works offline and online
• Supports Microsoft® Windows NT®, Windows® 2000, Windows® Server
2003, Novell Netware, and Linux operating systems
- User Guide 1
- Audience assumptions 2
- Contents 3
- Front panel components 7
- Front panel LEDs and buttons 8
- Rear panel components 10
- Rear panel LEDs and buttons 11
- System board components 12
- System maintenance switch 13
- System board LEDs 14
- Internal USB connector 17
- Fan module location 18
- Server operations 19
- Preparation procedures 20
- Removing the access panel 21
- Installing the access panel 22
- Server operations 23 23
- Removing the fan assembly 25
- Installing the fan assembly 26
- Server setup 27
- Rack planning resources 28
- Optimum environment 29
- Temperature requirements 30
- Power requirements 31
- Rack warnings 32
- Installing hardware options 33
- Server setup 35 35
- Registering the server 36
- Introduction 37
- Memory options 37
- DIMM installation guidelines 38
- Installing DIMMs 38
- Hard drive options 39
- Removing a hard drive blank 40
- Hard drive guidelines 40
- Installing a SATA hard drive 40
- Server cabling 47
- SATA cable routing 48
- SCSI cable routing 49
- Configuration tools 51
- HP ROM-Based Setup Utility 53
- Array Configuration Utility 54
- Management tools 56
- Automatic Server Recovery 57
- ROMPaq utility 57
- Erase Utility 59
- Management Agents 60
- HP Systems Insight Manager 60
- Redundant ROM support 61
- Diagnostic tools 63
- Array Diagnostic Utility 64
- HP Insight Diagnostics 64
- Integrated Management Log 64
- Keeping the system current 65
- Resource Paqs 66
- ProLiant Support Packs 66
- Care Pack 67
- Battery replacement 69
- 5. Remove the battery 70
- Troubleshooting 71
- Important safety information 72
- Warnings and cautions 73
- Troubleshooting 75 75
- Symptom information 76
- Service notifications 77
- Loose connections 77
- Diagnostic steps 77
- Start diagnosis flowchart 78
- Troubleshooting 79 79
- General diagnosis flowchart 80
- Troubleshooting 81 81
- Power-on problems flowchart 82
- Troubleshooting 83 83
- POST problems flowchart 85
- OS boot problems flowchart 87
- Troubleshooting 89 89
- Troubleshooting 91 91
- Other information resources 93
- Electrostatic discharge 95
- FCC rating label 98
- Class A equipment 98
- Class B equipment 99
- Modifications 100
- Mouse compliance statement 100
- Japanese notice 102
- BSMI notice 102
- Korean notice A&B 103
- Laser compliance 103
- Battery replacement notice 104
- Server specifications 107
- Specification 108
- Technical support 109
- Customer self repair 110
- Acronyms and abbreviations 111
- Wake-on LAN 115
Produits connexes et manuels pour Serveurs HP DL320 - ProLiant - G3
Serveurs HP Proliant DL580 Spécifications
(97 pages)
(97 pages)
Serveurs HP BL680c G5 Guide de l'utilisateur
(100 pages)
(100 pages)
Serveurs HP DL380z Guide de l'utilisateur
(133 pages)
(133 pages)
Serveurs HP HP ProLiant DL385 Spécifications
(106 pages)
(106 pages)
Serveurs HP ML150 - ProLiant - G6 Spécifications
(114 pages)
(114 pages)
Serveurs HP Z200 Spécifications
(192 pages)
(192 pages)
Serveurs HP Server tc3100 Spécifications
(111 pages)
(111 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.125 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels