Hp P6000 Command View Software Manuel d'utilisateur télécharger pdf (Page 10)

IMPORTANT: The new IP address will be lost if the storage system is later uninitialized or

the HP P6000 management module is reset.

8. Remove the LAN cable to the private network or laptop and reconnect the cable to the public

network.

9. From a computer on the public network, browse to https://new IP address:2373 and

Procedure when on a private network (initial setup)

Use this procedure when the HP P6000 management module is connected through a private

network.

1. Press and hold the recessed Reset button for 4 to 5 seconds, then release it. This sets an IP

address of 192.168.0.1/24 (IPv4) and fd50:f2eb:a8a::7/48 (IPv6) in private address space.

The green indicator on the top left corner of the LAN connector (Ethernet jack) will flash during

the reset, which may take up to 2 minutes. When the reset operation is completed, the green

indicator light will turn solid green.

IMPORTANT: At initial setup, you cannot browse to the HP P6000 Control Panel until you

perform this step.

1. LEDs 2. LAN connector 3. Reset button

2. Browse to https://192.168.0.1:2373 (IPv4) or https://fd50:f2eb:a8a::7/48

(IPv6) and log in as a storage administrator. The default user name is admin. No password

is required during the initial setup. The HP P6000 Control Panel GUI appears.

IMPORTANT: HP recommends that you change or delete the default IPv4 and IPv6 addresses

to avoid duplicate address detection issues in your network.

HP recommends that you change the default passwords.

If you change the password for the storage administrator or storage user account for the HP

P6000 Control Panel, be sure to record the new passwords since they cannot be cleared

without resetting the HP P6000 management module.

3. Select Administrator Options > Configure Network Options.

4. Enter a new IP address and other network settings that apply.

IMPORTANT: Restrictions apply. See Management module IP addresses.

5. Click Save Changes. The IP address changes immediately, causing you to lose connectivity to

the Control Panel.

The new IP address is stored and remains in effect, even when the storage system is later shut

down or restarted.

IMPORTANT: The new IP address will be lost if the storage system is later uninitialized or

the HP P6000 management module is reset.

10 Working with a Control Panel

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

Pas de commentaire

Hp P6000 Command View Software Manuel d'utilisateur Page 10