Hp Integrity NonStop J-Series Manuel d'utilisateur télécharger pdf (Page 18)

Setting Up the ACL Tape Drives

M8605A and M8606A ACL Tape Drive Installation and User’s Guide—546012-002

2-2

Setting Up the M8605A ACL Rackmount Unit

a. Push back the tabs in the top of the template and place them in the correct

holes in the mounting rack. Match up the hole pattern indicated on the sides of

the template with the hole pattern in the mounting rack.

b. Make sure to begin measuring in the correct place. If a unit is already installed

immediately below the planned position of the new unit, then place the

template against the front of the mounting rack and rest it on top of the

previously installed unit.

c. Use the front of the template to mark the attachment points for mounting

brackets, rails, components, or cage nuts on the back of the storage cabinet.

d. Use the back of the template to mark the attachment points for the mounting

brackets, rails, components, or cage nuts on the back of the storage cabinet.

3. Remove the template.

4. Install the slide members for the rackmount unit.

5. If the slide members are already installed, attach the front and rear mounting

brackets to the outer and middle slide members.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 79 80

Pas de commentaire

Hp Integrity NonStop J-Series Manuel d'utilisateur Page 18