Hp Netserver E Server series Manuel d'utilisateur télécharger pdf (Page 38)

Chapter 3 Installing the HP Support Anywhere Software

NOTE You cannot install the Support Anywhere software while the

SNMP service is running. If the SNMP service is running on

your HP NetServer, Support Anywhere setup will detect it and

stop it for you.

4. Choose "Install SNMP agent and Web Interface software."

5. Based on the printout you generated at the end of Client Setup (Part 1),

identify your NetServers as either web or non-web.

6. When server setup is complete, restart the server. Once the server has

restarted, the SNMP service should start up automatically. If it does not,

initiate the service manually, then change the startup configuration (in

Control Panel/Services) for automatic startup.

Repeat steps 1 through 6 for each Windows NT server listed in the printout you

created at the end of Client Setup (Part 1).

Part 3. Verify Correct Installation

To verify correct installation, return to the client workstation.

When Client Setup (Part 1) is complete, the Client automatically starts polling

the NetServers included on the Managed Servers List. However, because Server

setup (Part 2) was not completed at that time, each NetServer on the list

generates a Server Down message, indicating that either your server is down, or

that the SNMP service at the server is not running.

The first Auto Alert notifications you receive are always Server Down messages

(see the following figure).

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 103 104

Pas de commentaire

Hp Netserver E Server series Manuel d'utilisateur Page 38