Hp Netserver L Server series Manuel d'utilisateur télécharger pdf (Page 56)

Chapter 8 Mounting the NetServer in a Rack

◊ The "bar nut" is a two-holed metal bar used to secure the mounting

flanges of the slide to the rack columns (see Figure 8-5).

Place bar nut

behind outside

face of column.

Start two screws

in bar nut but do

not tighten.

Figure 8-5. Where to Place Bar Nuts

◊ The bar nut is placed behind the outside face of the column, at the

correct height as determined elsewhere in this chapter. Two screws are

inserted through the correct holes on the front columns. Start (but do

not tighten) both screws in the bar nut.

◊ The slots in the mounting flange allow you to insert the flange in place

behind the outside face but in front of the bar nut.

◊ The mounting flange is then positioned behind the column face, but in

front of the bar nut (see Figure 8-6).

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 153 154

Pas de commentaire

Hp Netserver L Server series Manuel d'utilisateur Page 56