Hp NonStop G-Series Manuel d'utilisateur télécharger pdf (Page 16)

Overview and Hardware/Software Requirements for

Mid-Range Silo Media Manager (MSMM)

Mid-Range Silo Media Manager Installation and User’s Guide—541530-003

1-2

MSMM Connection Configuration Overview

In order for the MSMM software to control the tape library, a tape library control path

must be configured from the HP NonStop S-series system to the tape library. The

system controls the movements of the tape library’s robotic arm. In this case the

system is a HP NonStop S-series.

HP NonStop S-series Systems

The tape library control path can be configured to run on one of the following

controllers:

•

Processor Multifunction Controller (PMF CRU)

•

ServerNet/DA SCSI ServerNet Addressable Controller (S-SAC).

For configuration examples and command syntax, see the SCF Reference Manual for

the Storage Subsystem. The tape library control path is configured in SCF using the

"ADD SCSI" command.

Example:

ADD SCSI $SL500, SENDTO STORAGE, PRIMARYLOCATION

(1,1,51),PRIMARYSAC 1, SCSIID 5, PRIMARYCPU 1, BACKUPCPU 0

The tape library control path physically connects from the PMFC or ServerNet/DA S-

SAC via a copper cable to the tape library. The cable connection should not exceed

seventy-five feet (75 ft.) or twenty-three meters (23m).

Note. The preceding example is for the tape library control path (robotic arm) on a PMFC.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 209 210

Pas de commentaire

Hp NonStop G-Series Manuel d'utilisateur Page 16