Hp ProLiant BL25p Server-Blade Manuel d'utilisateur télécharger pdf (Page 41)

Local I/O Cabling 41

CAUTION: Before disconnecting the local I/O cable, observe

the following guidelines:

•

Completely log out of the current iLO session before disconnecting

from the iLO port. Do not remove the local I/O cable when the UID

LED is flashing.

Always squeeze the locking buttons on the side of the server blade

connector before disconnecting from the I/O port. Failure to do so

can result in damage to the equipment.

Connecting Locally to a Server Blade with Video and

USB Devices

To connect locally, use the local I/O cable and any of the following USB devices:

Monitor

USB hub

USB keyboard

USB mouse

USB CD-ROM drive

USB diskette drive

Numerous configurations are possible. This section offers two possible

configurations.

Accessing a Server Blade with Local KVM

CAUTION: Disconnect the local I/O cable when not in use.

The port and connector do not provide a permanent connection. Rear

iLO connector performance degrades when the local I/O cable is

connected, even if the iLO connector on the cable is not in use.

NOTE: For this configuration, a USB hub is not necessary. To connect

additional devices, use a USB hub.

1. Connect the local I/O cable to the server blade.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 117 118

Pas de commentaire

Hp ProLiant BL25p Server-Blade Manuel d'utilisateur Page 41