Hp ProLiant BL45p Server series Manuel d'utilisateur télécharger pdf (Page 47)

Local I/O cabling 47

CAUTION: Before disconnecting the local I/O cable, observe

the following guidelines:

•

Completely log out of the current RILOE session before

disconnecting from the RILOE port. Do not remove the local I/O

cable when the UID LED is flashing.

Always squeeze the locking buttons on the side of the server blade

connector before disconnecting from the I/O port. Failure to do so

can result in damage to the equipment.

Connecting locally to a server blade with video and

USB devices

To connect locally, use the local I/O cable and any of the following USB devices:

Monitor

USB hub

USB keyboard

USB mouse

USB CD-ROM drive

USB diskette drive

Numerous configurations are possible. This section offers two possible

configurations.

Accessing a server blade with local KVM

CAUTION: Disconnect the local I/O cable when not in use.

The port and connector do not provide a permanent connection. Rear

RILOE connector performance degrades when the local I/O cable is

connected, even if the RILOE connector on the cable is not in use.

NOTE: For this configuration, a USB hub is not necessary. To connect

additional devices, use a USB hub.

1. Connect the local I/O cable to the server blade.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 127 128

Pas de commentaire

Hp ProLiant BL45p Server series Manuel d'utilisateur Page 47