Hp ProLiant BL465c Server Blade Manuel d'utilisateur télécharger pdf (Page 13)

Operations 13

After initiating a virtual power down command, be sure that the server blade goes into standby mode by

observing that the system power LED is amber.

Remove the server blade

To remove the component:

1. Identify the proper server blade.

2. Power down the server blade (on page 12).

3. Remove the server blade.

4. Place the server blade on a flat, level work surface.

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and

the internal system components to cool before touching them.

CAUTION: To prevent damage to electrical components, properly ground the server blade before

beginning any installation procedure. Improper grounding can cause ESD.

Remove the access panel

To remove the component:

1. Power down the server blade (on page 12).

2. Remove the server blade (on page 13).

3. Lift the access panel latch and slide the access panel to the rear.

4. Remove the access panel.

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and

the internal system components to cool before touching them.

CAUTION: To prevent damage to electrical components, properly ground the server blade before

beginning any installation procedure. Improper grounding can cause ESD.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 86 87

Pas de commentaire

Hp ProLiant BL465c Server Blade Manuel d'utilisateur Page 13