Hp ProLiant DL380e Gen8 Server Manuel d'utilisateur Page 46
- Page / 142
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Hardware options installation 46
Drive cable options
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP Product Bulletin website (http://www.hp.com/go/productbulletin).
Two-port SATA cable option
When the two-port SATA cable option is installed in the 8-bay drive cage, the server supports the 6-drive
SATA configuration. In this configuration, drive bays 1 through 6 are populated, while drive bays 7 and 8
contain drive blanks.
To connect the cable option:
1. Power down the server (on page 20).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 20).
o Remove the server from the rack (on page 22).
4. Remove the access panel (on page 23).
5. Remove the air baffle (on page 24).
6. Remove the PCI riser cages (on page 25).
7. Connect the two-port SATA cable:
a. Connect the cable to the drive sideband signal connector.
b. Secure the cable in the cable clip.
c. Connect the cable to the SATA storage and optical drive connectors.
d. Route the cable along the side of the system board towards the front chassis, and then connect the
cable to the drive backplane.
LFF drive
- User Guide 1
- Contents 3
- Contents 4 4
- Contents 5 5
- Contents 6 6
- Component identification 7
- • 8+8-bay SFF drive model 8
- • 12-bay LFF drive model 8
- • 25-bay SFF drive model 8
- Front panel LEDs and buttons 9
- Rear panel components 10
- Item Description 11
- Rear panel LEDs and buttons 12
- System board components 13
- DIMM slot locations 14
- System maintenance switch 14
- Drive numbering 15
- Drive LED definitions 16
- FBWC module LED definitions 17
- Fan locations 19
- Operations 20
- Remove the access panel 23
- Install the access panel 24
- Remove the air baffle 24
- Install the air baffle 24
- Remove the PCI riser cages 25
- Install the PCI riser cages 26
- Optimum environment 28
- Temperature requirements 29
- Power requirements 30
- Server warnings and cautions 31
- Rack warnings 32
- Installing hardware options 33
- Registering the server 35
- Introduction 36
- Security bezel option 36
- Drive options 36
- Installing a hot-plug drive 37
- Rear drive cage options 38
- Drive cable options 46
- Mini-SAS cable option 47
- Mini-SAS Y-cable options 48
- Controller options 49
- Optical drive option 54
- Hot-plug fan module option 55
- Fan population guidelines 56
- 4. Do one of the following: 57
- Memory options 60
- HP SmartMemory 61
- DIMM identification 62
- Memory protection modes 63
- Memory population guidelines 64
- Installing a DIMM 66
- Processor option 67
- Expansion board options 72
- GPU power cable option 74
- Cabling 83
- 4 SFF SATA cabling 84
- 6 LFF SATA cabling 84
- 6 SFF SATA cabling 85
- 8 LFF cabling 85
- 8 SFF cabling 87
- 8+8 SFF cabling 89
- 12 LFF cabling 92
- 25 SFF cabling 94
- 2 LFF rear drive cabling 95
- 2 SFF rear drive cabling 96
- Capacitor pack cabling 97
- Cabling 98 98
- Optical drive cabling 99
- GPU power cabling 99
- Dual-rank GPU 100
- Primary GPU power cabling 100
- Secondary GPU power cabling 101
- Server mode 102
- HP product QuickSpecs 102
- HP iLO Management 102
- Active Health System 103
- Intelligent Provisioning 104
- HP Insight Diagnostics 105
- Erase Utility 105
- HP Insight Online 106
- HP Service Pack for ProLiant 107
- HP ROM-Based Setup Utility 108
- Boot options 109
- Configuring AMP modes 109
- Utilities and features 110
- ROMPaq utility 111
- Automatic Server Recovery 111
- USB support 111
- Keeping the system current 112
- Version control 113
- ProLiant servers 113
- Troubleshooting 115
- System battery replacement 116
- Regulatory information 118
- Electrostatic discharge 119
- Specifications 120
- Specification Value 122
- Support and other resources 126
- Customer Self Repair 128
- Reparo feito pelo cliente 130
- Acronyms and abbreviations 134
- Documentation feedback 138
- Index 139 139
- Index 140 140
- Index 141 141
- Index 142 142
Produits connexes et manuels pour Matériel informatique Hp ProLiant DL380e Gen8 Server
(110 pages)
(82 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.073 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels