Hp ProLiant WS460c Gen8 Graphics Server Blade Manuel d'utilisateur télécharger pdf (Page 37)

Setup 37

Setup

Overview

Installation of a workstation blade requires the following steps:

1. Install and configure an HP BladeSystem c-Class enclosure.

2. Install any workstation blade options.

3. Install interconnect modules in the enclosure.

4. Connect the interconnect modules to the network.

5. Install a workstation blade.

6. Complete the workstation blade configuration.

Installing an HP BladeSystem c-Class enclosure

Before performing any workstation blade-specific procedures, install an HP BladeSystem c-Class enclosure.

The most current documentation for workstation blades and other HP BladeSystem components is available

at the HP website (http://www.hp.com/go/bladesystem/documentation).

Documentation is also available in the following locations:

• Documentation CD that ships with the enclosure

• HP website (http://www.hp.com/go/hpsc)

Installing server blade options

Before installing and initializing the workstation blade, install any workstation blade options, such as an

additional processor, hard drive, or mezzanine card.

Installing interconnect modules

For specific steps to install interconnect modules, see the documentation that ships with the interconnect

module.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 97 98

Pas de commentaire

Hp ProLiant WS460c Gen8 Graphics Server Blade Manuel d'utilisateur Page 37