Hp TC2120 Manuel d'utilisateur télécharger pdf (Page 94)

Chapter 7 Replacing Parts

6. Slide the drive out of the drive cage.

7. Remove the four screws to remove the rails from the drive.

8. Place the removed drive in an anti-static bag for protection.

Replacing a Hard Disk Drive (Drive Cage Mounted)

1. Set the jumper on the back of the drive to “CS” (Cable Select). Refer to the hard disk drive documentation

for detailed instructions.

2. Align and screw the rails to the new drive.

Use the shoulder screws located above the drive cage.

Figure 7-6. Releasing the Retaining Clips

NOTE If the hard disk drive (HDD) you are planning to install

already has a mounting tray attached, you must remove it

before you can install the drive into the drive cage.

Drive Slide Rails

Retaining Clips

(Do not remove

drive cage from

chassis.)

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 124 125

Pas de commentaire

Hp TC2120 Manuel d'utilisateur Page 94