Hp DL120 Manuel d'utilisateur télécharger pdf (Page 58)

Removal and replacement procedures 58

Remove the expansion board from its protective packaging, handling it by the edges.

Some expansion boards can only be installed in one slot but other boards can be configured to

fit in either slot by replacing the default bracket (attached to the board) with a different sized

one. The different sized bracket and instructions on how to attach it to the board is included in

the option kit.

5. Verify that the board’s default bracket is compatible with the configuration of the selected slot.

If it is not compatible, replace the bracket with one that is compatible.

6. Install the expansion board.

a. Slide the expansion board into the slot (1).

Make sure the board is properly seated in the slot.

b. Secure the expansion board with the one screw (2).

7. Reinstall the PCI riser board assembly to the chassis.

8. Connect the necessary cable(s) to the board.

Refer to the documentation that came with the board.

9. Perform the post-installation procedure.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 107 108

Pas de commentaire

Hp DL120 Manuel d'utilisateur Page 58