Hp DL120 Manuel d'utilisateur télécharger pdf (Page 71)

Removal and replacement procedures 71

Remove the default power supply unit.

Reuse the three screws you removed in this step for installing the new PSU.

a. Remove the two PSU screws on the rear panel (1).

b. Remove the single PSU screw on the side of the chassis (2).

c. Lift up the PSU from the chassis (3).

4. Install the new power supply unit.

a. Lay down the new unit in the PSU section of the chassis (1).

b. Insert the two PSU rear panel screws (2).

c. Insert the one PSU screw on the side chassis (3).

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 107 108

Contents 3
Customer self repair 5
Customer self repair 6 6
Customer self repair 7 7
Customer self repair 9 9
Customer Self Repair 10
Reparo feito pelo cliente 11
Customer self repair 12 12
Customer self repair 13 13
Customer self repair 14 14
Customer self repair 15 15
Illustrated parts catalog 16
System components 21
HP contact information 26
Required tools 27
Server warnings and cautions 27
Symbols on equipment 28
Pre-installation procedure 29
Post-installation procedure 30
Powering down the server 30
Cable management 31
System covers 32
Secondary access panel 33
Drive bay configuration 34
Hard disk drive 36
To install a hard drive: 37
Optical disc drive 42
System board configuration 46
Processor installation 47
To apply thermal compound: 50
To install the new processor: 50
To install the heat sink: 51
To install a memory module: 53
Expansion board 54
PCI riser board assembly 55
• Compliance 57
• Form factor 57
System battery 59
Option kits 61
PCI-X riser board 64
System fans 67
To replace a system fan: 68
Power supply unit 69
Diagnostic tools 73
Phoenix BIOS software 74
To run the Setup Utility: 75
Key Functions 76
Setup Utility menus 77
Advanced menu 78
Security menu 79
Boot menu 80
Exit menu 81
• 2 – 3: Configure BIOS 82
Loading system defaults 84
Clearing CMOS 84
Power-On-Self-Test 85
Connectors and components 88
Rear panel 89
System board 90
System buttons and jumpers 91
System jumpers 92
Status LED indicators 93
System board LED indicators 94
System specifications 95
–1.3375V 1.0V–1.33375V 97
Intel Xeon Dual-Core 98
Intel Xeon Quad-Core 98
Intel Core 2 Duo Desktop 99
–264 VAC 100
–240 VAC, 3A at 230 VAC 100
–48°C (+50 –118.4°F) 100
Software specifications 101
Physical specifications 102
Environmental specifications 103

Commentaires sur ces manuels

Pas de commentaire

Hp DL120 Manuel d'utilisateur Page 71

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de cinéma à domicile Hp DL120