HP OmniBook 7100 Manuel d'utilisateur télécharger pdf (Page 23)

2-2 Removal and Replacement HP OmniBook 7100

Notes

Reassembly steps are the reverse of the removal steps. Reassembly notes are included at the

end of each section below.

Symbols like this throughout this chapter show approximate full-size screw outlines. You

can use them to verify the sizes of screws before you install them. Installing a wrong-size screw

can damage the unit. (The symbol at the left represents an M2.5×5mm screw.)

Table 2-2. Required Equipment

• Small Phillips screwdriver, preferably magnetized.

• 5 mm hex driver.

• Probe or tweezers.

• Small flat-blade screwdriver.

• Needle-nose pliers.

• IC insertion/removal tool.

Table 2-3. Recommended Screw Torques

Screw Thread Size Torque (kgf•cm) Torque (in•lbf)

M2 1.5 – 2.0 1.3 – 1.7

M2.5

except those below

1.5 – 2.5 1.3 – 2.2

M2.5

for display brackets and hinge mounts

4.5 3.9

M3 2.0 – 2.5 1.7 – 2.2

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 86 87

Pas de commentaire

HP OmniBook 7100 Manuel d'utilisateur Page 23