HP OmniBook 7100 Manuel d'utilisateur télécharger pdf (Page 38)

HP OmniBook 7100 Removal and Replacement 2-17

9. Using a 5 mm hex driver, remove the standoff from the middle of the motherboard

10. Remove two screws that hold the motherboard to the bottom case.

11. Remove the screw that holds the left hinge mount to the motherboard, and the screw that holds the

right hinge mount to the motherboard.

12. Remove eight screws that hold the I/O plate:

• Three screws on the bottom of the unit.

• Four screws inside the I/O door near the hinge mounts.

• One screw from the top-center of the I/O plate.

13. Lift the front edge of the motherboard until it clears the bottom case, then slide the board forward

and lift it out.

Figure 2-11. Removing the Motherboard (Part 2)

Screw, M2.5×6mm

Screw, M2.5×4mm (4)

Screw, M2.5×4mm

Standoff, 12mm

Screw, M2.5×4mm

Screw, M2.5×8mm

Screw, M2×12mm

Front-IR cable

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 86 87

Pas de commentaire

HP OmniBook 7100 Manuel d'utilisateur Page 38