HP LX800 Manuel d'installation télécharger pdf (Page 34)

2. To make the delta or star configuration, use the metal strips and configure them according to the

table. Use an M7 socket wrench to secure them.

Curing Module Configuration

1. Remove all the T10 screws securing the right cover of the curing module and remove the cover.

TIP: The heating module cover you must remove is marked with orange tape.

2. There is a strap that does not allow you to remove the terminal block. Remove this strap, taking

care that you replace it after making the configuration.

3. Remove the T15 screw securing the terminal block and pull it out for easy access.

4. To make the delta or star configuration, use the metal strips and configure them according to the

table. Use an M7 socket wrench to secure them.

30 Chapter 6 Configure the electrical system ENWW

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 85 86

Pas de commentaire

HP LX800 Manuel d'installation Page 34