HP LX800 Manuel d'installation télécharger pdf (Page 52)

12. Wear gloves and use a cloth to remove the air purgers, as some ink may spill. When you have

finished removing the air purgers, close the carriage cover and access window. Press OK to finish.

13. At this point, check to make sure that the rear ink leakage sensor is correctly placed at the bottom

of the tray (it should be touching the tray).

14. From the front panel, enter the diagnostic menu and select Purge and Setup Menu > Force

Normal Boot .

15. The printer sets the boot configuration.

48 Chapter 7 Purge the ink system ENWW

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 85 86

Pas de commentaire

HP LX800 Manuel d'installation Page 52