HP 132A Manuel d'utilisateur télécharger pdf (Page 293)

100

101

Chapter 4 Command Reference

Introduction

Programming Guide 4-127

*ESE <NRf>

(Standard Event Status Enable Command)

*ESE?

(Standard Event Status Enable Query)

*ESE <NRf>

*ESE?

Sets or queries the Standard Event Status Enable Register, shown in Figure 4-4.

The parameter and query response value, when rounded to an integer value and

expressed in base 2 (binary), represents the bit values of the Standard Event

Status Enable Register. The value of unused bits is zero when queried and ignored

when set.

This register is used to enable a single or inclusive OR group of Standard Event

Status Register events to be summarized in the Status Byte Register (bit 5).

Figure 4-4. The Standard Event Status Enable Register

See the section titled “Standard Event Status Register Group,”

page 3-24, in Chapter 3 of this guide for a detailed description of the Standard

Event Status Register.

0 to 255

Numeric data transferred as ASCII bytes in <NR1> format.

• At power-on, the Standard Event Status Enable Register is cleared (value is

0).

• This value is unaffected by *RST and save/recall.

<NRf> Range

<NRf>

Resolution

Query Response

Comments

1 2 ... 288 289 290 291 292 293 294 295 296 297 298 ... 329 330

Commentaires sur ces manuels

Pas de commentaire

HP 132A Manuel d'utilisateur Page 293

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle HP 132A