HP Ethernet BL-c Switch Manuel d'utilisateur télécharger pdf (Page 21)

Installing the switch 21

Switch IP addresses are acquired by default using BOOTP, therefore, each switch has a unique IP

address. Each switch is remotely accessed from a central deployment server and an individual switch

configuration is downloaded to meet specific network requirements. See the HP 1:10Gb Ethernet BL-c

Switch Command Reference Guide for additional information on using a TFTP server to upload and

download configuration files.

Installing the switch

CAUTION: Do not cable the switch until after configuration.

IMPORTANT: Make sure that the server NIC configuration matches the switch bay selected.

NOTE: When installing two switches, there is one switch interconnect port between adjacent

I/O bays. Port 17 is disabled by default. The port must be manually enabled to use.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 65 66

Pas de commentaire

HP Ethernet BL-c Switch Manuel d'utilisateur Page 21