HP 12M Manuel d'installation télécharger pdf (Page 21)

2-7

Installing the HP 10/100 Hubs

Installation Procedures

Installing the HP 10/100 Hubs

2. Partially install a screw (5/8-inch number 12-24) into the top hole of a pair

of holes that are 0.5 inches apart in each rack/cabinet upright as shown

in the illustration below. Ensure that the screws are at the same level in

each upright.

3. Place the hub in the rack and lower it so the notches in the bottom of the

bracket slide onto the screws, then tighten these screws.

Partially install a screw

into the top hole of a

close (0.5-inch) pair on

both sides of the rack

lower the hub with the

mounting brackets onto

the partially installed

screws

9934.book Page 7 Thursday, January 14, 1999 12:39 PM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 65 66

Pas de commentaire

HP 12M Manuel d'installation Page 21