HP 24SII Manuel d'utilisateur télécharger pdf (Page 39)



! "#$

  



IMPORTANT: Before you proceed with cabling, you must know

whether the devices to which you will connect the Model 24SII DES

are DTE (Data Terminal Equipment) or DCE (Data Communication

Equipment). The following devices are generally DTE: terminals,

printers, computers like the IBM PC. The following devices are DCE:

modems and some computers.

If your device transmits data on Pin 2 or receives data on Pin 3, it is

DTE. If your device receives data on Pin 2 and transmits data on Pin

3, it is DCE. However, to verify the interface requirements, please

refer to the Owner's Manual for your device.

The serial ports on the M24SII-V04 I/O module has DB-25 female

DCE connectors and use the following signals for communication:

DCE PORT SIGNALS

PIN# EIA-232 DIRECTION DESCRIPTION

1 PGND ---- Protective ground

2 TX Input Data in

3 RX Output Data out

4 RTS Input Internally enabled if no wire connected

(normally not used).

5 CTS Output -12V when DCE device's buffer is full.

6 DSR Output +12V when DCE device powers-up.

7 SGND ---- Signal ground

20 DTR Input Transmit enabled when +12 V.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 167 168

Pas de commentaire

HP 24SII Manuel d'utilisateur Page 39