HP 6000 Router Series Manuel d'installation télécharger pdf (Page 32)

32 CHAPTER 3: CONFIGURING THE ROUTER

5 Set HyperTerminal properties. Select [Property/Settings] on the HyperTerminal and

enter the property setting window, shown below. Select VT100 or auto detection

as terminal simulation type, press [Ok] and return to the HyperTerminal window.

Powering on the Router Perform the following to check items before powering on the router:

■ Whether the power cord and ground wire are correctly connected.

■ Whether the voltage of the power supply complies with the requirement of

the Router.

■ Whether the console cable is correctly connected, whether the PC or

terminal for configuration is started, and whether the settings are done.

Before switching on the power, locate the power switch in the equipment room,

so that, in case of an electrical accident, power can be turned off.

1 Power up the Router. Confirm the following while the router is booting:

■ Whether the LEDs on the front panel are normal.

■ Whether the configuration terminal display is normal. For the local

configuration, the booting interface displays on the configuration terminal

after the Router is powered on.

2 Upon completion of POST, press <Enter> to begin configuring router.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 81 82

Pas de commentaire

HP 6000 Router Series Manuel d'installation Page 32