HP 706C Manuel d'utilisateur télécharger pdf (Page 41)

It is still possible to plot dynamically through Print Master if required.

When plotting in this fashion, you would probably need to increase the

input inactivity timeout value to a higher number than factory default

(20 seconds). Plotting dynamically would not allow you to utilize the

buffering capabilities of Print Master because the data stream from

the computer is not continuous. The dynamic method of plotting

would allow only one user at a time access to the plotter due to the

fact that the plotter can only respond back to the user who is currently

connected through Print Master.

 

All Print Master models have a green power LED and either six, eight,

or ten red activity LEDs. The green power LED will illuminate

whenever power is applied to the unit. The red LEDs indicate activity

on the respective port(s) when illuminated while the unit is in

operation mode. All red LEDs will illuminate briefly when the unit first

powers up and goes through its self-test.

When a computer sends a print job to Print Master, the LED for the

computer port and the selected printer port will illuminate. The

computer LED will remain illuminated until a disconnection occurs as

described in

Section 6.2.5

. The printer LED will typically remain

illuminated until the connection with the sending computer is

terminated. However, the printer LED may remain illuminated in the

event multiple computers are sending print jobs to that printer

simultaneously or if the printer attached to it goes off line (e.g., runs

out of paper).

Whenever configuration mode for the model 706A or 708A is

accessed (see

Section 7.1

), all red activity LEDs will illuminate.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 122 123

Pas de commentaire

HP 706C Manuel d'utilisateur Page 41